Código parte: DS-3E1106HP-EI(O-STD)
4 × 100 Mbps PoE RJ45 ports, 2 × 100 Mbps network RJ45 ports
IEEE 802.3at/af/bt standard for PoE ports
Network topology management, and alarm push
6 KV surge protection for PoE ports
Más infromación: DS-3E1106HP-EI(O-STD)
General |
Carcasa Metal material, IP40 |
Peso Neto 0.245 kg (0.54 lb) |
Peso Bruto 0.645 kg (1.42 lb) |
Dimensiones (W X H X D) 145.0 mm × 25.6 mm × 68.45 mm (5.7" × 1.0" × 2.69") |
Temperatura De Funcionamiento 0 °C to 40 °C (32 °F to 104 °F) |
Temperatura De Almacenamiento -40 °C to 85 °C (-40 °F to 185 °F) |
Condiciones De Humedad 5% to 95% (no condensation) |
Humedad Relativa 5% to 95% (no condensation) |
Fuente De Alimentación 48 VDC, 1.35 A |
Modo De Instalación Desk-Mounted,Wall-Mounted |
Max. El Consumo De Energía 65 W |
Consumo De Energía En Inactivo 2 W |
Surge Protection 6 KV |
Parámetros De Red |
Puertos 4 × 10/100 Mbps PoE port,2 × 10/100 Mbps RJ45 port |
Tabla De Direcciones MAC 2 K |
Capacidad De Conmutación 1.2 Gbps |
Tasa De Reenvío De Paquetes 0.90 Mpps |
Caché Interna 768 Kbits |
Fuente De Alimentación PoE |
PoE Standard IEEE 802.3af,IEEE 802.3at,IEEE 802.3bt |
Pin De Alimentación PoE 8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-) |
Puerto PoE |
Hi-PoE: Port 1 |
PoE: Ports 2 to 4 |
Max. Puerto De Alimentación 60 W,30 W |
PoE Power Budget 60 W |
Función De Software |
Largo Alcance |
Ports 1 to 4: up to 300 m. |
Long range performance may vary depend on camera model or cable condition. |
VIP Port Ports 1 to 2: data on VIP ports is preferentially forwarded when bandwidth resources are insufficient. |
PoE Watchdog Ports 1 to 4: auto detect and restart the cameras that do not respond. |
Port Isolation/HPP |
Support one-click activation and remote management via Hik-Partner Pro. Functions supported: |
1. Display the port rate. |
2. Display the port bandwidth utilization rate. |
3. Display the PoE power usage. |
4. Display topology information. |
5. Display the alarm status. |
6. Restart ports and devices. |
7. Enable port long-rage mode. |
8. Remotely upgrade the device. |
Link Aggregation/ |
System Maintenance |
Support device management via web. |
Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. |
Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. |
Support management via Hik-Central Pro. |
Support remote management via Hik-Partner Pro. |
Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. |
Supports 802.1ab LLDP for peer device discovery. |
Support SNMP v1/v2c for third-party management platform access. |
Support port mirroring for fault locating. |
QoS/Storm Control |
Storm control is used to prevent switch ports from being blocked by broadcast or multicast storms in the LAN, which may affect network communication. |
Supports port rate limiting based on broadcast, multicast, and unknown unicast packets. |
DHCP Snooping |
DHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through Off by default. |